diy Home Bathroom
Home 3D Design Bathroom Kitchen Living Room Bedroom Landscape Deck Patio Pool Garden  

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Download

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Home Design Software

Bathroom Design

 

 

Before installing the custom tile designs for bathrooms, clean up the whole floor, make sure that there is no water or oil or anything that may cause problem while you try to set tiles on the floor with adhesive. Take your time and work carefully and methodically remembering that the key is preparation and planning. Make sure your surfaces are suitable; the surface must be smooth, level and dry. Any existing wooden floorboards should be covered with 12mm (1/2in) exterior grade plywood sheets screwed down to form a level working surface. Concrete floors are of course the perfect base but before you commence work check that there is a damp-proof course.

 

 

Bathroom Ideas

 

 
Bathroom Design Software   Small Bathroom Ideas
 
Bathroom Tile Ideas   Master Bathroom Ideas

 

If not you should have one installed before starting work. You will need to fill any rough, ragged or uneven areas in the concrete with a self-levelling compound. Master bathroom floor tile design ideas and floor layouts. Plan the layout of your tiles so you know where they will all go before you even think about laying the first one. It is best to lay them out in the room to see how it will look. Pay close attention to corners, fitted cabinets, baths and toilets etc. You must remember that the tiles need to be laid out so that any part tiles do not show up in highly visible areas. Laying floor tiles around those areas where cuts are necessary is the trickiest part of tiling but if you take your time, measure and cut carefully, you should be able to get excellent results.

 

 

do it yourself

 

 

As already stated the secret of successful diy tiling is to spend time working out the tile positions - this is called setting out. First mark the mid-points of the longest wall and that is most visible from all the others and repeat for the adjacent shorter wall. Make chalk lines from each of the marks you have made so that you have a pair of lines that cross. . These lines should be perpendicular to each other. A chalk snap line is an inexpensive way to "draw" a long line between two points, when a ruler is not feasible. Then, hook one end of the chalk snap line to your beginning point. If you have a well-functioning chalk snap line, you can slowly play out the line without using the crank.

 


Bathroom Design

 

 
3D Bathroom Software   Bathroom Remodeling
 

How to Tile a Bathroom

 

Shower Enclosures

 

If the line plays out with difficulty, then be sure to use the crank to reduce the strain on the line. The way to get an accurate chalk line is having the chalk line pulled very tight when you snap it, as the more tension is on the string when you pull it up the more precise the line will be when you let go. Make sure the line is firmly resting against the floor surface. If there is any gap between the line and the surface, then it will not work. Hold back the line one inch as if drawing back the string for a bow and arrow. Let go: that is your "snap."


 

diy Home Network

 


 

Home | 3D Software | Bath | Bedroom | Basement | Living Room | Deck | Patio | Garden | Landscape | Kitchen | Contact | Privacy Policy | Site Map


DIY Home Network

DIY Home Network © 2010 - A Digital Design Space Company - All Rights Reserved